DustShield Blade Cover for Bosch GTS 10xc
Assembly instructions
Optimize your workshop with the installation instructions for the GTS 10 XC
Dust Cover. Step-by-step instructions for easy installation of the
Effective dust protection. Discover how to protect your saw from dust.
It protects and creates a cleaner working environment!
Light
- 2mm; 3mm Allen key
- Hex bit holder for taps
- Phillips screwdriver PH2
Step 1: Dismantling the saw blade cover
Lay the table saw on its left side to gain access to the lower opening of the saw.
Step 2: Dismantling the saw blade cover
Loosen the two screws with a PH2 screwdriver and open the cover on the underside of the saw.
Step 3: Dismantling the saw blade cover
Remove the five screws from the black cover and take out the cover.
Step 4: Dismantling the saw blade cover
If you selected the thread cutter when ordering,
Use it to thread the four anchor points with an M5 thread.
The thread cutter is a bit-type thread cutter and can be used with common
Hex adapters are used. Carefully cut the threads;
Pre-drilling is not necessary. Finally, vacuum out the blind holes.
into which the threads were cut. If you use the tap
If you have not selected one, please use a suitable one.
M5 tap for cutting the threads yourself.
Take this opportunity to thoroughly clean the saw box before continuing with the assembly.
Step 5: Mounting on the saw blade box
Look at the inside of the removed cover and thread the polyester fabric into the four tabs of the cover.
Step 6: Mounting on the saw blade box
Turn the cover over so that the outside of the cover is on top.
Place the two red 3D-printed blocks over the polyester fabric.
the black cover, so that the polyester fabric is clamped.
Step 7: Mounting on the saw blade box
Place the cover, including the polyester fabric and blocks, back into the saw.
1. Reattach the black cover to the saw blade housing, whereby
You only use three of the five original screws. At the points where
The blocks are, use the supplied M5x16 cylinder head screws.
Step 8: Mounting on the saw blade box
Attach the polyester fabric to the underside of the saw table.
Places where the thread was previously cut. Use the
supplied M5x6 cylinder head screws with washers. The existing middle threads are used for this purpose. M4x6 cylinder head screws with washers. First, loosely screw in all the screws and then tighten them once all the screws are in place.
Step 9: Control
Finally, check whether the saw blade is properly aligned with the angled cut.
Polyester fabric collides. A work inspection is necessary, also.
when a collision should not actually be possible.
Step 10: Reward
Great job, you did it! Gummy bears are waiting for you as a reward. Enjoy!